THE BODY SWAP IS NOT TO HARD , AND LOOKS GREAT !
HAVE NOT HEARD OF ANYONE MOVEING THE CONTROLLER TO CENTER POD
IT WOULD INVOLVE A MASIVE RE-WIRE
WHY DO YOU WANT TO MOVE IT ?
It was mounted in the seat pod from factory. Its an express 6 with 8 6v batteries. The 2 extra batteries are put where the controller normally mounts and where the charger plug would go.
Center pod has to be changed to match rest of body color! Is the pic of a txt or an express 6? The controller and solenoid were mounted in the factory pod which was a full pod mounted to floor. The Titan pod is mounted to floor by the framing of pod! The plastic body for the pod is only a few inches deep not going all the way to floor! I tried posting a pic of cart before I took it apart but the pic is to large!
OK LOOKING AT BODY INSTALL THE CHARGER PLUG GOES IN REAR SEAT
OK I SEE THE CENTER POD INSTALL
YOU COULD INSTALL THE CONTROLLER UP SIDE DOWN UNDER CENTER POD
I WOULD PUT AN ALUMINUM PLATE TO HOLD IT BETTER AND DEFLECT HEAT
The controller is mounted upright withe solenoid on the bracket. I'm thinking of using a black tote and cutting a hole in the pod to enclose it and protect it and also hide the wires n cables
Do you like customizing your golf cart? Or just looking for golf cart help? Then join the golf cart forum for golf cart enthusiasts owned & operated by golf cart enthusiasts. It takes less than 30 seconds! Everybody is welcome here. This Notice will disappear once Registered!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.